Fixed MTP to work with TWRP

Documentation/devicetree/bindings/ata/sata_highbank.txt

@@ -0,0 +1,44 @@
+* Calxeda AHCI SATA Controller
+
+SATA nodes are defined to describe on-chip Serial ATA controllers.
+The Calxeda SATA controller mostly conforms to the AHCI interface
+with some special extensions to add functionality.
+Each SATA controller should have its own node.
+
+Required properties:
+- compatible        : compatible list, contains "calxeda,hb-ahci"
+- interrupts        : <interrupt mapping for SATA IRQ>
+- reg               : <registers mapping>
+
+Optional properties:
+- dma-coherent      : Present if dma operations are coherent
+- calxeda,port-phys : phandle-combophy and lane assignment, which maps each
+			SATA port to a combophy and a lane within that
+			combophy
+- calxeda,sgpio-gpio: phandle-gpio bank, bit offset, and default on or off,
+			which indicates that the driver supports SGPIO
+			indicator lights using the indicated GPIOs
+- calxeda,led-order : a u32 array that map port numbers to offsets within the
+			SGPIO bitstream.
+- calxeda,tx-atten  : a u32 array that contains TX attenuation override
+			codes, one per port. The upper 3 bytes are always
+			0 and thus ignored.
+- calxeda,pre-clocks : a u32 that indicates the number of additional clock
+			cycles to transmit before sending an SGPIO pattern
+- calxeda,post-clocks: a u32 that indicates the number of additional clock
+			cycles to transmit after sending an SGPIO pattern
+
+Example:
+        sata@ffe08000 {
+		compatible = "calxeda,hb-ahci";
+		reg = <0xffe08000 0x1000>;
+		interrupts = <115>;
+		dma-coherent;
+		calxeda,port-phys = <&combophy5 0 &combophy0 0 &combophy0 1
+					&combophy0 2 &combophy0 3>;
+		calxeda,sgpio-gpio =<&gpioh 5 1 &gpioh 6 1 &gpioh 7 1>;
+		calxeda,led-order = <4 0 1 2 3>;
+		calxeda,tx-atten = <0xff 22 0xff 0xff 23>;
+		calxeda,pre-clocks = <10>;
+		calxeda,post-clocks = <0>;
+        };