Fixed MTP to work with TWRP

drivers/usb/phy/phy-am335x.c

@@ -0,0 +1,147 @@
+#include <linux/module.h>
+#include <linux/platform_device.h>
+#include <linux/dma-mapping.h>
+#include <linux/usb/otg.h>
+#include <linux/usb/usb_phy_generic.h>
+#include <linux/slab.h>
+#include <linux/clk.h>
+#include <linux/regulator/consumer.h>
+#include <linux/of.h>
+#include <linux/of_address.h>
+
+#include "am35x-phy-control.h"
+#include "phy-generic.h"
+
+struct am335x_phy {
+	struct usb_phy_generic usb_phy_gen;
+	struct phy_control *phy_ctrl;
+	int id;
+};
+
+static int am335x_init(struct usb_phy *phy)
+{
+	struct am335x_phy *am_phy = dev_get_drvdata(phy->dev);
+
+	phy_ctrl_power(am_phy->phy_ctrl, am_phy->id, true);
+	return 0;
+}
+
+static void am335x_shutdown(struct usb_phy *phy)
+{
+	struct am335x_phy *am_phy = dev_get_drvdata(phy->dev);
+
+	phy_ctrl_power(am_phy->phy_ctrl, am_phy->id, false);
+}
+
+static int am335x_phy_probe(struct platform_device *pdev)
+{
+	struct am335x_phy *am_phy;
+	struct device *dev = &pdev->dev;
+	int ret;
+
+	am_phy = devm_kzalloc(dev, sizeof(*am_phy), GFP_KERNEL);
+	if (!am_phy)
+		return -ENOMEM;
+
+	am_phy->phy_ctrl = am335x_get_phy_control(dev);
+	if (!am_phy->phy_ctrl)
+		return -EPROBE_DEFER;
+	am_phy->id = of_alias_get_id(pdev->dev.of_node, "phy");
+	if (am_phy->id < 0) {
+		dev_err(&pdev->dev, "Missing PHY id: %d\n", am_phy->id);
+		return am_phy->id;
+	}
+
+	ret = usb_phy_gen_create_phy(dev, &am_phy->usb_phy_gen, NULL);
+	if (ret)
+		return ret;
+
+	ret = usb_add_phy_dev(&am_phy->usb_phy_gen.phy);
+	if (ret)
+		return ret;
+	am_phy->usb_phy_gen.phy.init = am335x_init;
+	am_phy->usb_phy_gen.phy.shutdown = am335x_shutdown;
+
+	platform_set_drvdata(pdev, am_phy);
+	device_init_wakeup(dev, true);
+
+	/*
+	 * If we leave PHY wakeup enabled then AM33XX wakes up
+	 * immediately from DS0. To avoid this we mark dev->power.can_wakeup
+	 * to false. The same is checked in suspend routine to decide
+	 * on whether to enable PHY wakeup or not.
+	 * PHY wakeup works fine in standby mode, there by allowing us to
+	 * handle remote wakeup, wakeup on disconnect and connect.
+	 */
+
+	device_set_wakeup_enable(dev, false);
+	phy_ctrl_power(am_phy->phy_ctrl, am_phy->id, false);
+
+	return 0;
+}
+
+static int am335x_phy_remove(struct platform_device *pdev)
+{
+	struct am335x_phy *am_phy = platform_get_drvdata(pdev);
+
+	usb_remove_phy(&am_phy->usb_phy_gen.phy);
+	return 0;
+}
+
+#ifdef CONFIG_PM_SLEEP
+static int am335x_phy_suspend(struct device *dev)
+{
+	struct platform_device	*pdev = to_platform_device(dev);
+	struct am335x_phy *am_phy = platform_get_drvdata(pdev);
+
+	/*
+	 * Enable phy wakeup only if dev->power.can_wakeup is true.
+	 * Make sure to enable wakeup to support remote wakeup	in
+	 * standby mode ( same is not supported in OFF(DS0) mode).
+	 * Enable it by doing
+	 * echo enabled > /sys/bus/platform/devices/<usb-phy-id>/power/wakeup
+	 */
+
+	if (device_may_wakeup(dev))
+		phy_ctrl_wkup(am_phy->phy_ctrl, am_phy->id, true);
+
+	phy_ctrl_power(am_phy->phy_ctrl, am_phy->id, false);
+
+	return 0;
+}
+
+static int am335x_phy_resume(struct device *dev)
+{
+	struct platform_device	*pdev = to_platform_device(dev);
+	struct am335x_phy	*am_phy = platform_get_drvdata(pdev);
+
+	phy_ctrl_power(am_phy->phy_ctrl, am_phy->id, true);
+
+	if (device_may_wakeup(dev))
+		phy_ctrl_wkup(am_phy->phy_ctrl, am_phy->id, false);
+
+	return 0;
+}
+#endif
+
+static SIMPLE_DEV_PM_OPS(am335x_pm_ops, am335x_phy_suspend, am335x_phy_resume);
+
+static const struct of_device_id am335x_phy_ids[] = {
+	{ .compatible = "ti,am335x-usb-phy" },
+	{ }
+};
+MODULE_DEVICE_TABLE(of, am335x_phy_ids);
+
+static struct platform_driver am335x_phy_driver = {
+	.probe          = am335x_phy_probe,
+	.remove         = am335x_phy_remove,
+	.driver         = {
+		.name   = "am335x-phy-driver",
+		.owner  = THIS_MODULE,
+		.pm = &am335x_pm_ops,
+		.of_match_table = am335x_phy_ids,
+	},
+};
+
+module_platform_driver(am335x_phy_driver);
+MODULE_LICENSE("GPL v2");